Rev: C [Type text] Page 1 of 15 -- TSP-200 -- (THE PARK OUTDOOR BASKETBALL SYSTEM) Installation Instructions Keep this instruction manual in case y
Rev: C [Type text] Page 10 of 15 Install Post: a. Carefully position the post onto the ground anchor kit, install hardware as shown. NOTE: Do no
Rev: C [Type text] Page 11 of 15 Install Outrigger & Support Arms: a. Lift outrigger over top of post & lower into position. b. Apply a
Rev: C [Type text] Page 12 of 15 Install Actuator: a. Apply a small amount of grease to the hex bolt. b. Assemble as shown. M18 Hex Bolt
Rev: C [Type text] Page 13 of 15 Install Board: a. Using actuator, lower outrigger to the lowest position. b. Assemble as shown. NOTE: Do not t
Rev: C [Type text] Page 14 of 15 Install Rim / Edge Padding: a. Assemble rim and edge padding onto the backboard. Final Adjustments / Plumb U
Rev: C [Type text] Page 15 of 15 Lower Raise Lower Raise Labels / Pad: a. With the rim set at the 10 FT height. Apply labels for height as shown
Rev: C [Type text] Page 2 of 15 1. 2 Adjustable Wrenches 6. 1-1/16” Wrench 2. MM / Inch Socket Set 7. Tape Measure 3. 17MM Wrench 8. Hamme
Rev: C [Type text] Page 3 of 15 JAYPRO SPORTS TSP-200 THE PARK ITEM QTY IMAGE DESCRIPTION 1 1 6” x 6” x 106-1/4” LONG SQUARE UPRIGHT POST 2 1 OUT
Rev: C [Type text] Page 4 of 15 ITEM QTY IMAGE DESCRIPTION 6 1 FOOTING PLATE 7 1 42” x 72” ACRYLIC BACKBOARD (P/N: ACRB-72M) 8 1 PAIR OF BACKBOAR
Rev: C [Type text] Page 5 of 15 ITEM QTY IMAGE DESCRIPTION 10 1 LYNCH PIN WITH ROUNDED RETAINER 11 1 SAFELY BAR 12 4 J-BOLT WITH PRE-ASSEMBLE HA
Rev: C [Type text] Page 6 of 15 ITEM QTY IMAGE DESCRIPTION 18 1 M16 NYLON LOCK NUT 19 2 M18 x 318mm LONG HEX BOLT 20 1 M18 x 240mm LONG HEX BOLT
Rev: C [Type text] Page 7 of 15 ITEM QTY IMAGE DESCRIPTION 27 4 M12 NYLON LOCK NUT 28 4 PRE-ASSEMBLE HARDWARE 1X M10 HEX NUT 2X M10 WASHER 1X M10
Rev: C [Type text] Page 8 of 15 INSTALLATION TIP / REFERENCE OVERALL VIEW
Rev: C [Type text] Page 9 of 15 Footing: NOTE: Before digging, call to locate any buried utility lines. a. Dig a hole 48" deep x 36" a
Comments to this Manuals