WWW.JAYPRO.COM Page 1 11/1/13 Installing the Jaypro Max-1 Adjustable Crossbar Football Goal Posts Models: FBGP-520AX/FBGP-820AX (Expandable
WWW.JAYPRO.COM Page 10 11/1/13 Figure 5: Installation of the Standard 60-1/4-inch Ground Sleeve (See Figure 6 for installation of the 63-1/2-inch
WWW.JAYPRO.COM Page 11 11/1/13 See Figure 5 for installation of the standard 60-1/4” ground sleeve .
WWW.JAYPRO.COM Page 12 11/1/13 7 Install the Gooseneck (No Height Adjuster) The procedure below describes the installation of the gooseneck into
WWW.JAYPRO.COM Page 13 11/1/13 a. It is strongly recommend that an 11/16” transfer punch be used to locate the holes to ensure correct alignment
WWW.JAYPRO.COM Page 14 11/1/13 Figure 7: Installation of the Gooseneck in the Standard Ground Sleeve
WWW.JAYPRO.COM Page 15 11/1/13 8 Install the Gooseneck with Height Adjuster The procedure below describes how to install the gooseneck into the gr
WWW.JAYPRO.COM Page 16 11/1/13 b. Tighten the 1/2”-13 jam nuts against the ground sleeve. 11. Drill two 5/8” holes in the gooseneck using the pr
WWW.JAYPRO.COM Page 17 11/1/13 Figure 8: Installation of the Gooseneck Using the Height Adjuster
WWW.JAYPRO.COM Page 18 11/1/13 9 Install the Gooseneck Without Ground Sleeve Installation Steps Follow these steps to install the goosenecks at ea
WWW.JAYPRO.COM Page 19 11/1/13 Figure 9: Installation of the Gooseneck Without Ground Sleeve See Figure 5 and for installation with ground sleeve
WWW.JAYPRO.COM Page 2 11/1/13 1 Introduction This user guide describes how to install the Jaypro Max-1 football goal post models FBGP-820AX,and FB
WWW.JAYPRO.COM Page 20 11/1/13 10 Install and Level the Crossbar Follow these steps to install and level the crossbar (refer to Figure 10 Installi
WWW.JAYPRO.COM Page 21 11/1/13 Figure 10: Installing and leveling the crossbar 11 Install the Wind Streamers Before installing the uprights,
WWW.JAYPRO.COM Page 22 11/1/13 3. Thread the ¼”-20 jam nut onto the eye-bolt, and thread the eye-bolt into the upright cap. 4. Tighten the jam
WWW.JAYPRO.COM Page 23 11/1/13 2. Rotate end fitting such that the upright insert is pointing downward at about a 45-degree angle. 3. Lift one
WWW.JAYPRO.COM Page 24 11/1/13 12.2 Installation of Second Upright and End Fitting 1. Repeat steps 1 through 9 of section 12.1 for the other end
WWW.JAYPRO.COM Page 25 11/1/13 4. Now go to the other end and install the upright to the High School position repeating the procedures as outline
WWW.JAYPRO.COM Page 26 11/1/13 Figure 13 Upright Spacing Figure 14 Anti-Rotation Screw NOTE: It is recommended that you use an Antiseize Lubr
WWW.JAYPRO.COM Page 27 11/1/13 Jaypro Sports, LLC 976 Hartford Turnpike Waterford, CT 06385 Phone: 800–243–0533 Phone:
WWW.JAYPRO.COM Page 3 11/1/13 Wrench Set Level, 3’ minimum 100-foot tape measure Electric Drill o Drill Bits: 5/16“, 1/2", and
WWW.JAYPRO.COM Page 4 11/1/13 2 63-1/2” EXTENDED ground sleeves (in place of the standard 60-1/4” sleeve), see Figure 2. Figure 1: FBGP-800AX &am
WWW.JAYPRO.COM Page 5 11/1/13 Figure 2: Height Adjuster Mechanism. FBGP-806K Figure 3: Comparison of ground sleeves.
WWW.JAYPRO.COM Page 6 11/1/13 FBGP-804 FBGP-805 5 Where to Install the Grou
WWW.JAYPRO.COM Page 7 11/1/13 Figure 4: Location of the Center of the Ground Sleeve All measurements from field-side edges of lines.
WWW.JAYPRO.COM Page 8 11/1/13 6 Install the Ground Standard Use of a ground sleeve allows the goalpost to be removed at a later date if necessary.
WWW.JAYPRO.COM Page 9 11/1/13 b. Refer to Figure 6 if you are installing the taller 63-1/2-inch ground sleeve. c. Skip ahead to Section 9 if
Comments to this Manuals